Flooring Services

MECHANICAL FLOORING PREPERATION

Danlaid Contracting specialises in the preparation of concrete floors leaving them ready to receive finishes such as vinyl, carpet, timber, ceramic tiles, and epoxy coatings. We have a number of ways of preparing the floor mechanically including the following methods:

 EPOXY FLOORING

 SCARRIFING

Danlaid Contracting specializes in epoxy flooring to supermarkets, both new and refurbished areas. Danlaid has experienced staff that can minimize the down time to the area being refurbished, such as Deli’s, Meat rooms, Produce areas or even the sealing of concrete in the back of house store room.

Read More...

 Available, again in a range of sizes, depending on suitability of the job at hand. A Scarrifyer shaves off the surface of the concrete in 5mm increments per pass, dependant on the strength of concrete being treated.

DIAMOND GRINDING

 REMOVAL OF FLOOR COVERING & TOPPING SCREED

Our range of diamond grinding machines, either single phase, 240 volt or 20 & 32 Amp 3 phase powered models are a dustless & quick method of removing a range of contaminants from the slab surface prior to installing or applying following floor finishes. Diamond Grinding is particularly useful where difficult access situations arise. When we remove vinyl, carpets, ceramic tiles and concrete screeds from the slab by either of these two methods.
      1/  Ride-on Hydraulic Stripper, Gas Powered
or   2/  Bobcat with a profiling Head attachment

CAPTIVE SHOT BLASTING

 CONCRETE REPAIR & PROTECTION

Our shot blaster is a 12E SPE and is capable of cleaning (for example) a slab of old adhesives at a rate of 400 - 600 m2 per shift. Shot blasting is a very effective method of roughening a concrete slab prior to resurfacing.

Danlaid Contracting has completed a bridge restoration project for Melbourne Water. The Project consisted of 5 bridges, where the concrete had to be protected and repaired.

Read More...